Support page for of
SL2 3.7L cases
Assembling a computer requires certain knowledge and skills! This brief instruction shows the assembly sequence and is intended for the user who has already assembled computers.
And also, the case in these photos may be a little different from what you have, it happens, I make some changes in almost every batch.
-
Preparation.
Make sure your assembly components match the case specifications. Remove the covers by unscrewing the screws and sliding them down.
-
Installation of the Power Supply Unit (PSU) .
The case supports the installation of flex 1U format PSU. If your PSU has a modular cable connection, we recommend that you connect the necessary ones before installation in the case. Install the PSU in the case and fasten with screws.
-
Installing the motherboard (MB) .
The case supports MB mini-ITX format. Read the instructions for the motherboard. Install everything you need on it (Processor, CPU cooler, RAM, NVMe drive, if used. Follow the instructions of the component manufacturer). Also unscrew the drive cage or even the side panel it attaches to. Install the MB plug in the case if it is not fixed on the motherboard before mounting the MB. Very carefully put the MB into the case, placing it on the racks. Screw the MB to the case using screws.
-
Installation of 2.5" Storage .
Skip this step if you don't plan to use a 2.5" drive.
If you decide to install two drives in the basket or one without it, it is important to understand that the thickness of the installed drives reduces the size (height) of the installed cooler.
Everything is simple with the installation, screws are attached, cables are connected, everything is ready.
-
The final collection.
Carefully route all cables using nylon cable ties. Check that all cables are connected. Install the covers on the case and fasten with screws.
