Support page for of
SL3m 2.9L cases
Assembling a computer requires certain knowledge and skills! This brief instruction shows the assembly sequence and is designed for the user who has already assembled computers .
And also, the body in these photos may be slightly different from what you have, it happens, I make some changes in almost every batch.
The components inside are very dense, which can cause difficulties during assembly.
-
Make sure your assembly components match the case specifications.
Disassemble the case by unscrewing the screws with a screwdriver.
-
Installing the motherboard (MB) .
The case supports MB mini-ITX format. Read the instruction manual for the motherboard. Install everything you need on it (Processor, CPU cooler, RAM, NVMe drive, if used. Follow the instructions of the component manufacturer). Install the plug in the case if it is not fixed on the motherboard before mounting the MB. Very carefully put the MB into the case, placing it on the racks. Screw the MB to the case using screws.
After installing the MB, install and screw the C8 connector to the case.
-
Installing a video card.
Connect the additional power supply of the video card, if provided by the video card manufacturer, before installing it (see the instructions for installing your video card in the video card delivery kit). Insert the video card into the case, insert the cable into the PCIe x16 riser connector as far as it will go. Screw the video card to the case.
WARNING! A riser cable 10-15 cm long can be included with the case, this is more than necessary. Fold the riser cable approximately as shown in the photo.
-
The case supports the installation of HDPlex 250W GaN AIO modules.
Connect the necessary cables to the power supply unit and screw it to the case with screws.
-
The final assembly.
Carefully route all cables using nylon cable ties. Check that all cables are connected. Install the cover on the body and fasten with screws.
