Support page for
of SLM2 5.7L cases
Assembling a computer requires certain knowledge and skills! This brief instruction shows the assembly sequence and is designed for the user who has already assembled computers .
Also, the case in these photos may be a little different from what you have, it happens, I make some changes in almost every batch.
-
Preparation.
Make sure your components match the case specification.
Disassemble the case by unscrewing the screws.
-
Installation of the Power Supply Unit (PSU).
The SLM2 5.7L rev.5 case is compatible with PSU HDPlex 250W, 500W GaN AIO.
Unscrew the mounting bracket from the housing. Screw it to the power supply unit with screws. Install the PSU with a screwed fastening in the case and put a 3 mm plate between it and the case, screw it to the case with screws.
-
The case SLM2 6L rev.6 is compatible with PSU flex 1U.
Unscrew the mounting bracket from the housing. Screw it to the power supply unit with screws. Install the PSU with a screwed fastener into the case and screw it to the case with screws.
-
Installation of 2.5" drives.
Skip this step if you don't plan to use 2.5" drives.
Connect the interface to the drive. Unscrew the mounting plate from the housing. screw one or two drives to it. Screw the plate with drives to the case with screws.
(in the photo, the SLM1 case)
-
Video card installation.
Skip this step if you do not plan to use a video card.
Connect the additional power supply of the video card before its installation, if it is provided by the manufacturer of the video card (see the instructions for installing your video card in the video card delivery kit). Unscrew the corner for fixing the video card from the case. If necessary, change the position of the riser cable for the video card. Install the video card in the riser cable and screw it to the case.
-
Installing the motherboard (MB).
Read the instructions for your MB. For your convenience, install everything you need on it (CPU, CPU cooler, RAM, NVMe drive, if used. Follow the instructions of the component manufacturer). Install the plug in the case, if it is not fixed on the motherboard, before mounting the MB. Connect the PCIe riser cable to the MB if you plan to install a video card. Screw the MB to the case using the screws and a magnetic screwdriver.
-
Final Assembly.
Carefully route all cables using nylon cable ties. Check all cables are connected, including the power button cable. Now you can install the cover by fastening them with screws. Also screw the vertical stand.
Photo SLM2 5.7L r.5
Photo SLM2 6L r.6
